Author Topic: Wanhao D9 Waggster Firmware v1.0  (Read 350 times)

CdRsKuLL

  • Administrator
  • Full Member
  • *****
  • Posts: 146
    • View Profile
Wanhao D9 Waggster Firmware v1.0
« on: February 22, 2020, 03:17:28 AM »

DeanFin

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Wanhao D9 Waggster Firmware v1.0
« Reply #1 on: May 21, 2020, 11:37:08 AM »
Anyway to adjust E Steps? I've been using the firmware (Fantastic) and just upgraded to a Titan extruder.

Cheers

CdRsKuLL

  • Administrator
  • Full Member
  • *****
  • Posts: 146
    • View Profile
Re: Wanhao D9 Waggster Firmware v1.0
« Reply #2 on: May 26, 2020, 02:07:45 AM »
You change this via code if you wish for now..  I think the easiest way is to write a gcode file and then print it.   So, to do this if you open notepad up and put the following in

G28 ;lets home first so you know its reading
M92 E415 ;sets the new esteps
M500 ;saves the esteps to eeprom
G0 Z50; brings the gantry up to 50mm so you know its finished.

Now.. if you save it as newsteps.gcode  and then copy it over to the SD card and print it.. that will be it :-) jobs done.

Let me know how you get on.  I will be adding a couple of buttons soon to the firmware so you will be able to swap between them in the future but this should get you going.

:-)

Steve