Author Topic: Adding the BLtouch back to prusa firmware  (Read 259 times)

jrmcswain

  • Newbie
  • *
  • Posts: 1
    • View Profile
Adding the BLtouch back to prusa firmware
« on: February 23, 2020, 03:05:21 PM »
I have an adimlab Gantry that I have swapped over to the Einsy Rambo board, I have the clone MMU2S unit. I swapped the Infrared filament sensor for a microswitch. I have the PINDA probe, but I also bought the BLTouch.  I would much rather use the BLTouch as I print on glass. I would like to keep the cool features of the PRUSA Firmware and add the BLTouch back. I tried Marlin 2.0 bugfix on my Wanhao D9-500 but it seemed to not keep the z offset and print correctly. This is the last hurdle, all the hardware is attached and fixed. I have been searching the internet but I don't find anything helpful.

Jack